Appendix B Leds; Mpu And Switching Fabric Module Leds - HP FlexNetwork HSR6800 Installation Manual

Appendix B LEDs

HPE HSR6800 routers provide LEDs for FRUs to indicate their operating status.

MPU and switching fabric module LEDs

The LEDs for the RSE-X2 and RSE-X3 are the same.
Figure 85 RSE-X2 LEDs
Table 63 RSE-X2 LED description
LED
(green)
(green/orange)
(yellow)
(red)
(red)
(green)
Status
Off
Steady on
CF
Flashing
Off
LINK Steady green
Steady orange
Off
ACT
Flashing
Off
ALM
Steady on
Off
PAL
M
Steady on
Off
ACT
Steady on
Figure 85
Description
No CF card is present or the CF card is not recognizable.
A CF card is in position and has been detected.
The system is accessing the CF card.
CAUTION:
In this state, do not insert or remove the CF card to avoid
damaging the file system on the CF card.
No link is present on the port.
A 1000 Mbps link is present.
A 10/100 Mbps link is present.
No data is being received or transmitted.
Data is being received or transmitted at 10/100/1000 Mbps.
The system is operating correctly and there is no alarm.
A fault has occurred to the system. In this state, check the
system log immediately.
The system power supply is operating correctly.
The available power is not efficient, or power supplies of
different specifications are inserted.
The MPU is in standby state.
The MPU is in active state.
117
uses the RSE-X2 as an example.