FIP-310 front panel
Figure 77 FIP-310 front panel
(1) Combo interface 1
(3) SFP+ port 0
(5) Combo interface 2
(11) HIM/MIM slot
FIP-310 specifications
Item
Memory type and size
NVRAM
Combo interface
10G Ethernet port
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-310 combo interface specifications
Specification of combo interfaces on the FIP-310 is the same as FIP-110. For more information,
see
Table 42
Remarks
•
Default—Two 2-GB DDR3 SDRAMs
•
Maximum—Two 2-GB DDR3 SDRAMs
128 KB
4
Copper ports (MDI/MDIX
autosensing)
Fiber ports
2
1 supported
1 supported
Supported
Supported
and
Table
43.
(2) Combo interface 3
(4) SFP+ port 1
(6) Combo interface 0
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex
100