Fip-240 - HP FlexNetwork HSR6800 Installation Manual

Item
HIM
MIM
Hardware encryption
Hot swapping
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the
copper port or the fiber port. To switch between the copper and fiber ports, use the combo
enable { copper | fiber } command in interface view. For more information about the combo
enable { copper | fiber } command, see HPE FlexNetwork HSR6800 Routers Interface
Command Reference.
• Use transceiver modules provided by Hewlett Packard Enterprise only. The router might be
incompatible with transceiver modules from other vendors. The system generates an alarm when
a transceiver module from another vendor is installed.
FIP-210 combo interface specifications
Specification of combo interfaces on the FIP-210 and the FIP-110 are the same. For more
information, see
Transceiver modules for the FIP-210 and for the FIP-110 fiber ports are the same. For more
information, see
Maximum interface modules provided by FIP-210 in full configuration
FIP/Interface
module
FIP-210
MIM
HIM

FIP-240

The FIP-240 provides two combo interfaces. It supports HIMs, MIMs, or a mix of HIMs and MIMs.
FIP-240 front panel
Figure 75 FIP-240 front panel
(1) Slot 4
(3) Combo interface 1
(5) Slot 1
Remarks
2 supported
2 supported
Supported
Supported
Table 42 and Table 43.
Table 44.
HSR6802
2
4
4
HSR6804
4
8
8
(2) Slot 3
(4) Combo interface 0
(6) Slot 2
96
HSR6808
8
16
16