Replacing A Cf Card; Replacing A Transceiver Module - HP FlexNetwork HSR6800 Installation Manual

Replacing a CF card

CAUTION:
To avoid hardware damage, do not remove the CF card when the router is booting or the CF LED is
flashing.
To replace a CF card:
Press the CF card eject button of the CF card reader so that the eject button projects from the
1.
panel.
Press the eject button again to eject the CF card part-way out of the CF card reader, and then
2.
pull the CF card out of the CF card reader.
Figure 47 Removing a CF card
Install a new CF card. For the installation procedure, see
3.

Replacing a transceiver module

Pressing the tab of the LC connector, pull out the LC connector from the transceiver module.
1.
Put on the dust cap for the LC connector.
Pivot the clasp of the transceiver module down to the horizontal position.
2.
Hold the clasp to gently pull the transceiver module out.
3.
Put the dust plug on the removed module, and put the removed module into its original shipping
materials.
Install a new transceiver module. For the installation procedure, see
4.
If you do not install a new transceiver module in the interface, install a dust-proof plug in the
interface.
Figure 48 Removing a transceiver module
"Installing a CF
42
card."
"Connecting a fiber cable."