Replacing An Lpu - HP FlexNetwork HSR6800 Installation Manual

Figure 44 Pulling the SFE-X1 out of the slot (HSR6808)
Install a new SFE-X1. For the installation procedure, see
4.
module."
If you do not install a new SFE-X1 in the slot, install a filler panel.

Replacing an LPU

CAUTION:
To avoid hardware damage, do not replace the LPU when its RUN LED is fast flashing.
To replace an LPU, for example, FIP-210:
Face the front of the router and locate the FIP module to be removed.
1.
Use a Phillips screwdriver to completely loosen the captive screws of the FIP module.
2.
Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward,
3.
and gently pull the FIP module out of the slot along the slide rails.
"Installing an SFE-X1 switching fabric
40