Replacing A Transceiver Module - HP A8800 Installation Manual

Figure 42 Replacing a CF card

Replacing a transceiver module

CAUTION:
When installing or removing an SFP transceiver module, do not touch the golden finger.
The replacement procedures for XFP and SFP transceiver modules are similar. This section uses an SFP
transceiver module as an example.
To replace a transceiver module:
Put on an ESD-preventive wrist strap, ensuring that the wrist strap makes good skin contact and
1.
is grounded.
Remove the optical fibers from the SFP transceiver module, pivot the clasp down to the
2.
horizontal position, and then pull SFP the transceiver module out of the socket as shown
in Figure
Put the removed SFP transceiver module in an antistatic bag or its original shipping materials.
3.
Unpack a new SFP transceiver module, pivot the clasp of the SFP transceiver module upward to
4.
the vertical position so that it catches a knob on the top of the SFP transceiver module, and then,
holding both sides of the SFP transceiver module, gently push the SFP transceiver module into
the socket until it has close contact with the socket (you can feel that the top and bottom spring
tabs catch in the socket), as shown in
Connect the optical fibers to the new SFP transceiver module.
5.
43.
Figure 44.
59