Configuration; Overview Of The Configuration Steps; Actual Values - JUMO mTRON T Operating Manual

Measuring, control, and automation system process engineering application

Hide thumbs Also See for mTRON T:

Table of Contents

3.1

The configuration of different input and output signals, texts, process steps, and program gen-

erators is required to use the process engineering application. This will be demonstrated here

as an example of a program generator.

The following steps are required for configuration:

1) Actual values: select analog signals to be displayed as actual values in the program gener-

ator

2) Alarms: select digital signals to trigger an alarm in the program generator; determine the

alarm texts; determine the alarm signal description; connect a signal to control a warning

device (e.g. horn) with a digital output

3) Process steps: define process steps including process contacts

4) "Door open" and "pause" events: deactivate process contacts (yes/no); select digital signal

(door contact)

5) Using process contacts: connect process contacts with digital outputs

6) Program generator: activate program generator; enter setpoint limits and descriptions; de-

fine temperature (setpoint value) for the section changeover (core temperature); determine

changeover condition (time/setpoint value)

7) Configure special PLC functions: section changeover; F value calculation; deltaT setpoint

value calculation

8) Setpoint values (program generator outputs): connect setpoint values with analog outputs;

use setpoint values as controller setpoint values

The following chapters describe the configuration with the setup program. Program creation will

not be dealt with here (for this see Chapter 2.3.3 "Program editor", page 21).

Further information about configuration can be found in the technical documentation of the

measuring, control, and automation system, particularly the central processing unit operating

manual (705001).

 Chapter 1.1 "Available technical documentation", page 5

3.2

Select analog signals to be displayed as actual values in the program generator

CPU > Configuration level > PLC configuration

3 Configuration

Table of Contents