Temporary Changes - JUMO mTRON T Operating Manual

2 Process screen operation
2.3.9

Temporary changes

Call up from automatic mode
With this function, the program editor is started in order to implement temporary changes in the
current program. During start, the program editor jumps to the current program section. Here,
the display of the section time will be updated cyclically. Previous sections (past) and subse-
quent sections (future) are also editable.
Temporary changes to setpoint values, program contacts, and section times are possible. If it
concerns the currently running program section, the remaining section time or alternatively the
section time (section duration) is changed. The changes to the section time or the remaining
section time are effective immediately after the time is entered. If it is the case that the section
status changes (from "in progress" to "not in progress" or the reverse) during the alteration of
the section time or the remaining section time, the time entry will be rejected.
Inserting or deleting program sections is not possible. Similarly, no changes can be made to
repetition cycles.
When the program ends (also via program abort), the temporary changes are deleted. When
the program restarts, the original program data is valid again.
36