JUMO mTRON T Operating Manual page 24

2 Process screen operation
Edit program
After pressing the "start program editor" control element (button), the program editor process
screen is displayed:
(1)
(2)
(1) Status bar:
"Edit program" symbol
"P" symbol (program) and program name
"P/i" symbol (number of program sections;
in this case: 3)
(2) Control elements (from left to right):
Previous section
Selected section (direct selection possible
by entering section number)
Next section
Insert empty section after the selected sec-
tion
Delete selected section
Copy selected section to cache
Insert copied section into any position in
the same program
Back (basic status)
Process step
When editing a program section, the process step must first be specified. The process step de-
termines which setpoint values are available and which limits are valid for the section time.
Process steps are created via configuration with the setup program.
 Chapter 3.4 "Process steps", page 48
24
(3) Program sections:
Previous section (for information only)
Selected section
Next section (for information only)
(4) Selected program section (partially edit-
able):
Section number (not editable)
Process step
Section time
Target (start section of the repetition)
Cycles (number of repetitions)
Setpoint values 1 to 8
Operating contacts 1 to 8
Setpoint values and section time are dis-
played in red in the case of limit value vio-
lation.
(3)
(4)