Adapt Plc Application To Hardware Assignment - JUMO mTRON T Operating Manual

Measuring, control, and automation system process engineering application

Hide thumbs Also See for mTRON T:

Table of Contents

3.10

Adapt PLC application to hardware assignment

The PLC application for process engineering only uses the central processing unit (CPU) and

the multifunction panel 840 (HMI) as supplied. If the hardware assignment is changed by the

user in the setup program to adapt it to an individual system (adding modules), the PLC appli-

cation must also be adapted:

Step

Activity

Start CODESYS in the setup program: Project > Project settings > PLC

➥ CODESYS starts and the PLC application is transferred from the setup program

to CODESYS. The new modules appear in the device list.

Transfer the project in CODESYS : Create > Retransfer

➥ The new modules are adopted in the PLC application.

In CODESYS, close the project (and CODESYS): File > Close

➥ The PLC application is transferred to the setup program again and CODESYS is

closed.

In the setup program, confirm the CODESYS note with "OK" and exit the "project

settings" dialog with "OK"

➥ The changes are adopted

Transfer the project to the system in the setup program

➥ The PLC application is stored permanently in the central processing unit.

3 Configuration

Table of Contents