Installation - ATEN CN-6000 User Manual

Installation

1. Make sure that power to any devices you will be connecting up have
been turned off. You must unplug the power cords of any computers
that have the Keyboard Power On function.
2. Make sure that all devices on the installation are properly grounded.
To install the CN-6000, refer to the diagram below (the diagram numbers
correspond to the numbered steps), and do the following:
1. Plug the local administrator's keyboard, mouse, and monitor into the unit's
Console Ports.
2. Use the KVM cable provided with this package to connect the CN-6000's
KVM Port, to the Keyboard, Video and Mouse ports of the server or KVM
switch that you are installing.
3. Plug the LAN or WAN cable into the CN-6000's RJ-45 socket.
4. Power up your server or KVM installation.
5. Plug the power adapter cable into the CN-6000's power jack, then plug the
power adapter into an AC power source.
2
KVM Switch
4
3
1
Hardware Setup
5
7