Hardware Setup; Front View - ATEN CN-6000 User Manual

Front View

1.
Reset / Firmware
Upgrade Switch
2. Data Speed LED
3.
Link LED
4.
Power LED
1
2
Pressing and holding this switch in while powering ON the
CN-6000 returns it to the factory default firmware level.
After the CN-6000 has been powered ON, pressing and
holding this switch in for more that two seconds performs a
system reset.
Note: This switch is recessed and must be pushed with a thin
object - such as the end of a paper clip, or a ballpoint pen.
The LED lights GREEN to indicate 10 Mbps data
transmission speed.
The LED lights ORANGE to indicate 100 Mbps data
transmission speed.
Flashes GREEN to indicate that a Client program is
accessing the device.
Lights ORANGE when the CN-6000 is powered up and
ready to operate.

Hardware Setup

3
4
Chapter 2.
5