ATEN CN-6000 User Manual page 79

When the Utility comes back up, it searches for all the the CN-6000 devices
installed on the local LAN segment and displays the results in the large central
panel (CN-6000 devices).
M
If the unit you wish to configure appears in the listbox, Double Click it.
M
If the unit you want doesn't appear in the listbox, key in its IP address in the
CN-6000 address field, and its Port number in the Port box, then Click
Login.
Note: 1. The Port number that corresponds to a unit's IP address is set by the
Administrator on the Network configuration page (see p. 16 for
details).
2. Clicking the Refresh button causes the utility to rescan the local
LAN segment for CN-6000 devices.
3. If the utlity fails to connect to a unit that you specified, it assigns
another free IP address (if one exists), to that device and attempts to
connect again.
4. When the Administrator Utility searches for CN-6000 devices, if it
finds them in different network segments (one at 10.0.0.xxx, and
another at 216.0.0.xxx, for example), it will attempt to substitute a
dynamic IP address (10.0.0.111, for example).
The Administrator Utility
11