Single Station Installation
To set up a single station installation refer to the diagram below (the numbers
in the diagram correspond with the numbers of the instruction steps), and do
the following:
1. Ground the CS1708i / CS1716i by connecting one end of the grounding
wire to the grounding terminal, and the other end of the wire to a suitable
grounded object.
2. Using the console cable provided with your switch, connect a USB or PS/2
keyboard, mouse, and monitor to the CS1708i / CS1716i console port.
(See Console Cable Installation Diagram on the following page.)
3. Use KVM cable sets (as described in the Cables section on page 6), to
connect any available KVM port to the keyboard, video and mouse ports
of the computer you are installing. (See KVM Cable Installation Diagrams
on the following page.)
4. Plug the power adapter cable into the CS1708i / CS1716i power jack, then
plug the power adapter into an AC power source.
After all the equipment has been connected up, power on the computers.
Single Station Installation Diagram
1
4
3
2
2. Hardware Setup
19