Hardware Setup; Front View - ATEN CN-6000 User Manual

Front View

1. Reset / Firmware Upgrade Switch
M
Pressing and holding this switch in while powering On the CN-6000 puts
the switch into Firmware Upgrade mode.
M
Pressing and holding this switch in for more that two seconds performs a
system reset.
Note: This switch is recessed and must be pushed with a thin object - such
as the end of a paper clip, or a ballpoint pen.
2. 10/100 Mbps Data LED
M
The LED lights GREEN to indicate 10 Mbps data transmission speed.
M
The LED lights ORANGE to indicate 100 Mbps data transmission speed.
3. Link LED
Flashes GREEN to indicate that a Client program is accessing the device.
4. Power LED
Lights when the CN-6000 is powered up and ready to operate.

Hardware Setup

1
2
3
4
Hardware Setup
Chapter 2.
5