Develop ineo+ 451 User Manual page 97

Copy Operations
– Select the punched hole position, and then touch [OK].
– Touch [Auto] to automatically determine the position of the punched holes according to the
orientation of the loaded document. If the document length is 297 mm or less, the holes are punched
along the long side of the paper. If the document length is more than 297 mm, the holes are punched
along the short side of the paper.
– If "Auto" is selected for the stapling position, load the document with the top toward the back of the
machine. If the document is loaded in any other orientation, the stapling will not be correctly
positioned.
– If "Auto" is selected, the punched hole position is set at the top or at the left.
– To cancel the setting and select the default, press the [Reset] key.
4
If desired, touch [Original Direction], and then select the setting appropriate for the document.
5
Touch [OK].
The Basic screen appears again.
ineo+ 650/550/451
2
2-59