Develop ineo+ 451 User Manual page 87

Copy Operations
Setting
Offset
Fold/Bind
Center Staple/Fold
Output Tray
Staple
ineo+ 650/550/451
Description
If no finisher is installed
If the sorting conditions are met, printed copies are fed out and sorted in an
alternating crisscross pattern.
If a finisher is installed
The copies are fed out and stacked on top of each other with each set shifted
to separate it.
Select one of these settings to fold copies. The copies can also be bound with
staples at the same time.
A Fold/Bind setting can be used if optional finisher FS-608 is installed.
Select this setting to fold copies. The copies can also be bound with staples at
the same time.
The "Center Staple & Fold" setting can be used if the saddle stitcher is installed
on optional finisher FS-519.
Select the output tray where the finished copies are to be fed.
This setting can be used if optional finisher FS-519 is installed.
Select one of these settings to bind the copies with a staple in the corner or
with two staples.
2
2-49