Develop ineo+ 451 User Manual page 129

Copy Operations
The Wide Paper screen appears.
5
Select the size of the paper to be loaded.
– Touch
– If tray 1 or 2 is set for wide paper, the size cannot be changed.
6
To change the size, touch [Change Size].
The Change Size screen for oversized paper appears.
7
Specify the X and Y sides of the paper, and then touch [OK].
– Touch either [X] or [Y], press the [C] (clear) key to clear the current setting, and then use the keypad
to type in the size.
– To store a paper size of 12 e 18 w, touch [12 e 18 w]. Enter values for "X" and "Y".
– If a value outside the allowable range is specified, the message "Input error" appears. Type a value
within the allowable range. The allowable range differs depending on the paper sizes.
– If the orientation of the loaded paper does not match the sizes specified for "X" and "Y", "Input
error" appears, even if the values are within the allowable range. In addition, do not enter the same
size for "X" and "Y".
– If the value was incorrectly entered, press the [C] (clear) key in the keypad to erase the value, and
then specify the correct value.
To cancel changes to the settings, touch [Cancel].
8
Touch [OK], and then touch [OK] in the next two screens that appear.
The Basic screen appears again.
Note
The selected size button is programmed with the entered paper size, so that the paper size is available
to be selected again without being typed in. In addition, the size can be changed.
ineo+ 650/550/451
and until the button for the desired paper size is displayed.
2
2-91