Selecting A Group Destination - Develop ineo+ 451 User Manual

Network Scanner Operations
3
Touch a destination button to select the address.
– Multiple destinations can be specified at the same time.
– Additional destinations can be added by directly typing in the address.
The button appears selected, and the destination appears under "Broadcast Destinations".
4
Touch [Scan Settings], [Original Settings] or [Communication Settings], and then specify the desired
scan settings.
– For details on the scan settings, refer to "Specifying scan and transmission settings (Scan
settings/original settings/communication settings)" on page 5-28.
5
Load the document into the ADF or place it on the original glass.
6
Press the [Start] key in the control panel.
Scanning of the document begins, and the data is sent.
Note
Do not turn off the machine until the scan job is deleted from the Job List screen.

Selecting a group destination

"Group" refers to multiple destinations that are registered collectively. Follow the procedure described below
to send data by selecting a group that has been registered in advance.
For details on registering group destinations, refer to "Registering a group destination" on page 5-77.
!
Detail
In order to select a group destination, "Address Book Default" (displayed by touching [Custom Display
Settings] on the User Settings screen, then [Fax/Scan Settings]) must be set to "Address Type"
If the destination types are not displayed in the index, touch [Search], and then search for destinations
in the group destination type.
1
Press the [Fax/Scan] key in the control panel.
The Fax/Scan mode screen appears.
ineo+ 650/550/451
5
5-13