Enabling Cwmp From The Cli - HP 5920 Configuration Manual

For an attribute, the CLI- and ACS-assigned values have higher priority than the DHCP-assigned value.
The CLI- and ACS-assigned values overwrite each other, whichever is assigned later.
This document only describes configuring ACS and CPE attributes from the CLI and DHCP server. For
more information about configuring and using the ACS, see ACS documentation.
To configure CWMP, perform the following tasks:
Tasks at a glance
(Required.)
Configuring ACS
•
(Required.)
Assigning ACS attributes from the DHCP server
Configuring the preferred ACS attributes from the
CLI
•
(Optional.)
the CLI
(Optional.)
•
Configuring ACS authentication parameters
•
Configuring the provision code
•
Configuring the CWMP connection interface
•
Configuring autoconnect parameters
Configuring the periodic Inform feature
Scheduling a connection initiation
Configuring the maximum number of connection
retries
Configuring the close-wait timer
•
Enabling NAT traversal for the CPE
•
Specifying an SSL client policy for HTTPS connection to
ACS

Enabling CWMP from the CLI

You must enable CWMP for other CWMP settings to take effect, whether they are configured from the CLI,
or assigned through the DHCP server or ACS.
To enable CWMP:
Step
1. Enter system view.
2. Enter CWMP view.
3. Enable CWMP.
Enabling CWMP from the CLI
attributes:
Configuring the preferred ACS attributes
Configuring the default ACS attributes from
Configuring CPE attributes:
Command
system-view
cwmp
cwmp enable
Remarks
To use CWMP, you must enable CWMP from the
CLI.
The preferred ACS attributes are configurable
from the CPE's CLI, DHCP server, and ACS.
The default ACS attributes are configurable only
from the CLI.
All CPE attributes are configurable from the CLI
and ACS except for the following attributes:
•
CWMP connection interface
•
NAT traversal
•
Maximum number of connection retries
•
SSL client policy for HTTPS
These attributes are configurable only from the
CLI.
Remarks
N/A
N/A
By default, CWMP is disabled.
223