Powtran PI8600 F Series User Manual page 88

Section V Parameter Function Table
Setting
value
0 No function
1 Fault Warning
2 Over current inspeciton
3 Over load inspeciton
4 Over voltage inspeciton
5 Less voltage inspeciton
6 Lower load inspection
7 Over heat inspeciton
8 Running state of command
9 Abnormal PID feedback signal PID feedback signal is abnormal
10 Motor state of REW running
11 Arrival of setting frequency
12 Arrival of upper frequency
13 Arrival of lower frequency
14 Arrival of FDT set frequency1 Arrive at frequency 1 FDT set
Deceleration running
Acceleration running
Arrival of high pressure
Arrival of low pressure
Arrival of inverter rate
current
Arrival of motor rate
current
Arrival of input frequency
lower limitation
Arrival of current upper
limitation
Arrival of current lower
limitation
Time to reach limit time 1
Time to reach limit time 2
Inverter ready to run
operation
Output content
23
24
25
26
27
28
29
30
31
32
33
34
Specification explaination
Setting "0", N output reaction, but inverter can
be controlled by theoretical terminal.
Inverter at fault or after fault with unconfirmed
status.
Inverter met fault of over current
Inverter met fault of over load of heat protection
Inverter met fault of over voltage
Inverter met fault of less voltge
Inverter met fault of lower load
Inverter met fault of over heat.
Inverter is under running state of command
Motor is reverse running
Arrive at set frequency
Arrive at upper frequency
Arrive at lower frequency
86