Powtran PI8600 F Series User Manual page 59

0 : keyboard+Rs485/CAN Control
1 : keyboard+Terminal+Rs485/CAN Control
control terminal, edge trigger, falling edge of the implementation of the Forward command
FWD / Reverse command REV, rising edge of the implementation of the STOP command
2 : Rs485/CAN Control
Under this function, only free stop funciont is valid under the keyboard control, other
operation control is invalid
3 : Terminal control, Level trigger.
Under this function,only free stop funciont is valid under the keyboard control,other operation
control is invalid
4 : The proportion linkage control
Select this function, the slave unit would execute the command from the proportion linkage
host unit.
Select this function, can also use keyboard, terminal, RS485 to control the proportion
linkage slave unit to run.
The proportion of linkage running,after stop the proportion linkage slave unit with the
keyboard terminal, Rs485, the slave unit will not run the proportion liknge host unit‟s
command, it needs once again to respond to host commands through the keyboard, terminal,
RS485, or the proportion linkage host sends stop command so that slave unit could respond
to run commands.
F06
V/F boost mode
1 bit: V/F promote curve
0 Line V/F curve: Suitable for ordinary constant torque load
1 Power of 1.2 V/F curve: Appropriate torque down V/F curve, Suitable for liquid loads
2 Power of 1.7 V/F curve: Appropriate torque down V/F curve, Suitable for liquid loads
3 Power of 2 V/F curve: Torque down V/F curve, It is suitable for fans, pumps, centrifugal
load
4 Define mode V/Fcurve: Can be customized appropriate curve according to the actual
situation .
10 bit: Auto-torque boost mode
0 Close Automatic torque boost
1 Open automatic torque boost
Beeline V/F curve
Power of 1.2 V/F curve
Power of1.7 powerV/Fcurve
1 bit
Power of 2 power V/F curve
Define mode V/Fcurve
Close automatic torque
boost
10 bit
Automatic torqueboost
VF mode 0 speed no Output
100 bit
VF mode keep 0 speed
57
Section V Parameter Function Table
0
1
2
3
4
0
1
0
1
- 0000 N