Multi Name - Yamaha SY99 Owner's Manual

MULTI EDIT MODE
Summary: The multi being edited can be given a
twenty-character name. In multi play mode, this
multi name will be displayed in large characters.
Procedure:
From: multi job directory
Select: job 08:Name
Specify: the name for the multi
Summary: The multi data being edited can be
initialized to a set of standard values.
Procedure:
From: multi job directory
Select: job 15:initlz
To execute: the initialize operation press YES.
To quit: without executing press NO or EXIT.
INITIALIZE MULTI
ARE YOU SURE ?
(Yes or No)
This function sets all multi data values to the mini-
mum or simplest possible settings. When you are
creating a new multi it is often convenient to start
with the initial settings.
If you are sure you want to initialize the multi
data, press YES and the data of the multi being
edited will be set to the values shown below. If you
decide not to initialize, press NO.
194

8. Multi name

(JUMP #400)
(JUMP #422)
Remarks: Methods of entering character data are
15. Initialize multi
(JUMP #400)
Enter a twenty-character name for the multi.
To clear the currently entered name press F1
(Clr). To switch to upper-case characters press
F2 (Uppr). To switch to lower case characters
press F3 (Lowr).
explained in How to enter character data, on
page 30.
Initialized settings for Multi data
01 Voice select
Preset 1 A01(01) GrandPiano (all channels)
02 Voice volume
Volume = 127 (maximum) (all channels)
03 Voice tuning
Tuning = ±0 (all channels)
04 Voice note shift
Note Shift = ±0 (all channels)
05 Voice static pan
Pan = ±0 (= center) (all channels)
06 Voice output group select
Output = both (all channels)
07 Effect set
*** same as normal voice initial data except for
Effect Send ***
(for each channel)
Effect send source = multi
Effect send select = all on
Effect send level = 127
08 Multi name
Name = INIT MULTI VOICE
JUMP #422