Copy Operator - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
Source Element Type: The type (AWM or AFM)
of each element in the selected voice is
displayed.
Destination Element Number: Specify the element
1-4 of the selected Source Voice which you want
to copy into the currently edited element. The
type (AWM or AFM) of the selected element
will be displayed in the Element Type line
above. The selected source element must be the
AFM ELEMENT DATA
Summary: While editing the parameters for oper-
ator EG or Output, you can copy EG and Output
data from one operator to another.
Procedure:
From: AFM element job 3 or 4
Press: COPY
Select: the data type, source operator, and
destination operator
To execute: the copy operation press F8 (Go)
AFM ELEMENT DATA
Summary: Select the Algorithm and specify feed-
back routings between operators.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 01:Algrthm., and press
Fl (Form)
Specify: the algorithm number, and feedback
sources and destinations
136

Copy operator

(JUMP #236-242)
1. (F1) AFM algorithm (Form)
(JUMP #231)
same type as the currently edited element. If
not, the bottom line will show "Element type
mismatch!"
After specifying the source voice and element, press
F8 (Go). The display will ask "Are you sure?". If
you are sure you want to copy the element data then
press YES, and the data will be copied.
Data Type: Select one of the following types of
data to be copied.
EG&OUTPUT: Envelope generator, output level
and scaling
EG: Envelope generator
OUTPUT: Output level and scaling
Source: The specified data will be copied from
this operator.
Destination: The specified data will be copied to
this operator.
Remarks: It is often the case that many or all oper-
ators in a voice have similar settings, especially
for EG parameters. In such cases you can save
time by setting the average EG for the voice on
one operator, and then copying it to the others.
Algorithm Number (1...45): Select the algorithm
to determine the "arrangement" of the six oper -
ators in an AFM element. Refer to the following
chart of the 45 algorithms. When you change the
Algorithm, the Src
plained below and the external input settings
explained in the following section will be
initialized.
FB1-FB3: Feedback can be drawn from three of
the operators in the algorithm and applied to any
operator that has an unused input.
Src 1-3 (OP1...OP6): Select the source of feed-
back for the three feedback routings. Any oper-
ator can be selected as the source of feedback.
In some algorithms, one or more feedback
JUMP #231
and Dst settings ex-