Controller Set - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
DRUM SET DATA
Summary: The overall volume of a drum set voice
can be adjusted using a specified controller.
Procedure:
From: drum set job directory
Select: 04:Controller Set
Specify: the minimum level and controller for drum
voice volume
Device (MIDI Control #): Select a controller
number 1—120 or aftertouch. For example when
"001 Modulation" is selected, the MODULATION
1 wheel will regulate the volume of the drum
voice. For a detailed explanation of controller
numbers, refer to Voice Common job 12.(F2)
Controllers, page 127.
DRUM SET DATA
Summary: Specify a ten-character name for the
voice being edited. In voice play mode this voice
name will be displayed in large characters.
Procedure:
From: drum set job directory
Select: 05:Drum Set Name
Specify: the drum voice name
176

4. Controller set

(JUMP #272)
(JUMP #275)
Remarks: In addition to the controller specified
5. Voice name
(JUMP #272)
(JUMP #229)
Vol Low Limit (Value 0...127): This determines
the lowest volume that can be set by the
selected controller. For example when this is set
to 80, the lowest position of the controller will
set fhe volume of the drum voice to 80. When
this is set to 0 the lowest position of the con-
troller will reduce the volume of the drum voice
to silence; When this is set to 127 the controller
will have no effect on the volume.
here, the volume of the entire SY99 can always
be controlled over its full range by an optional
foot controller connected to the rear panel VOL-
UME jack.
Enter a ten-character name for the drum voice.
To clear the currently entered name press Fl
(Clr). To switch to upper-case characters press
F2 (Uppr). To switch to lower-case characters
press F3 (Lowr).
For a detailed explanation of how to enter character
data, refer to How to enter character data.
JUMP #275
JUMP #229