Initialize Afm Element - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
When a note is played, the filter cutoff will
be adjusted by the amount of L0, and will change
at the rate of Rl to level L1. When the level
reaches L1, it will change at the rate of R2 to the
level of L2. When the level reaches L2, it will
change at the rate of R3 to the level of L3. When
the level reaches L3, it will change at the rate of
R4 to the level of L4. The filter cutoff frequency
will remain at the level of L4 as long as you con-
tinue pressing the key.
When you release the key, the filter cutoff
frequency will change at the rate of RR1 to the
level of RL1. When the level reaches RL1, it will
change at the rate of RR2 to the level of RL2.
AFM ELEMENT DATA
Summary: Initialize the AFM element data being
edited to a set of basic values.
Procedure:
From: AFM Element job
directory
Select: job 15:Initlz
To execute: the initialize operation press YES
To quit: without executing press NO or EXIT

INITIALIZE AFM ELEMENT

ARE YOU SURE ?
<Yes or No>
This function sets all AFM element data values to
the minimum or simplest possible settings. When
creating your own new voices it is usually best to
begin by editing an existing voice. However if you
want to start from scratch, this Initialize function
can be helpful.
154
15. Initialize AFM element
(JUMP #230)
Rate Scaling: On most acoustic instruments, high
notes have a naturally shorter attack and decay.
This can be simulated by setting rate scaling to
a positive value (+1...+7). The following dia-
gram shows how higher notes will have faster
rates (shorter EGs). Negative settings will
have the opposite effect.
If you are sure you want to initialize the AFM
element data, press YES. The AFM element data
being edited will be set to the values shown below.
If you decide not to initialize, press NO or EXIT.
This function initializes only AFM element data.
Other initialize functions are provided for initializing
Voice Common data and AWM element data. Refer
to Voice Common 15. Initialize voice or AWM ele-
ment 15. Initialize AWM element.
Initialized settings for AFM element data
01 Algorithm Set
Algorithm number
Feedback 1
Feedback 2
Feedback 3
Input Level 1
Input Level 1
Input Level 2
Noise
AWM Wave
= 30
= none (free)
= none (free)
= none (free)
= 7 (operator 1-5)
= 0 (operator 6)
= 0 (all operators)
= Off (all operators)
= Off (all operators)