Yamaha SY99 Owner's Manual page 222

This area numerically shows the data that will
be inserted at the cursor location. To specify the
type of data to be inserted, hold SHIFT and press
F1-F6 to enter one of the types of data explained
below. Move the cursor and modify the param-
eters as desired, and press ENTER to insert the
data at the current location.
To move to Change mode press F2 (Chng).
To move to Graph mode press F7 (Grph).
Note: The following display will appear, and you
can move the cursor to specify the following
data; location ("001-01-00/96", etc.), note num-
ber (Note 0...127), gate time (Gate 1...8188) in
multiples of 4, and note-on velocity (Velocity
I... 127).
Gate time is displayed as the number of
clocks (1/96th of a beat) that the note will be
held, but can be specified only in multiples of 4.
Step time (Step 0...9999) is displayed to
indicate the time until the next event, but cannot
be edited.
Program change: To enter program change data
hold SHIFT and press F2 (Prog). The following
display will appear, and you can move the cursor
to specify the the program change number
(Value 0...127). A program change of 0 will
select the first program; A01 in the case of the
SY99. The setting for MIDI Utility 1.Setting
(JUMP #807) will determine how program
changes are received. For details, see page 258.
Pitch bend: To enter pitch bend data hold SHIFT and
press F3 (PB). The following display will appear,
and you can move the cursor to specify the pitch
bend data (Value -8192...8191).
Control change: To enter control change data hold
SHIFT and press F4 (Ctrl). The following display
will appear, and you can move the cursor to
specify the control change number (Control
0...127) and control change data (Value
0...127). Control change number 123 cannot be
selected.
After touch: To enter after touch data hold SHIFT
and press F5 (AT). The following display will
appear, and you can move the cursor to specify
the aftertouch data (Value 0...127).
Relative tempo: To enter relative tempo data hold
SHIFT and press F6 (Temp). The following dis-
play will appear, and you can move the cursor to
specify the relative tempo change data (Value
10%...200%).
When playback reaches relative tempo data, the
playback tempo will change by the specified per-
centage. Relative tempo data will have an effect
only if the SY99 sequencer is synchronized to its
own internal clock. Refer to Song Setup job 2.MIDI
Control.
SONG MODE
2 1 1