Load From Disk - Yamaha SY99 Owner's Manual

UTILITY MODE
MDR: The number of files saved by the MDR
function (see MIDI data recorder utility, page
279)
Misc.: The number of all other types of files
DISK UTILITY
Summary: Synthesizer, sequencer, or card data can
be loaded from disk.
Procedure:
From: disk utility job directory (JUMP #816)
Select: 02:Load From Disk
Specify: the type of data to be loaded.
Press: ENTER
Select: the file from which to load the data.
To execute: the loading operation press F8 (Go).
To quit: without loading press EXIT.
Move the cursor in this area to select the type cf
data you wish to load from disk.
01: All Data: All data of the SY99
02: Synth All: 64 voices, 64 multis, 32 pan, 2
micro tuning, and system setup
03: Seq All: K-Seq data and setup data of the
sequencer section
04: Syn Setup: Synthesizer system setup data
from a disk file that was saved as "All
Data"
05: Vc & Mit: 64 voices, 64 multis, from a disk
file that was saved as "All Data"
06: Pan: 32 pan data from a disk file that was
saved as "All Data"
07: McrTuning: 2 micro tuning data from a disk
file that was saved as "All Data"
08: Seq Setup: Setup data from a disk file that
was saved as "All Data"
09: Song & Ptn: 1 song and pattern sequencer
data from a disk file that was saved as "All
Data"
266
Remarks: When this job is selected the currently

2. Load from disk

(JUMP #817)
Types of load operations: The data that can be
loaded by each operation depends on the type of
save operation that was used (refer to the following
section 3.Save to disk):
The load operation procedure may vary slightly de-
pending on the type of load operation selected.
Details are given below.
Load from disk (types 1-8 and 14): As the chart
inserted disk will be checked immediately, so be
sure to insert the disk before you select the job.
There are no settings to make in this job.
10: Other Seq: Sequencer data in K-Seq, E-Seq,
N-Seq, or standard MIDI file format
11: 1 Voice: A single selected voice from a disk
file that was saved as "All Data"
12: 1 Multi: A single selected multi from a disk
file that was saved as "All Data"
13: 1 Song: A song that was saved as "1 Song"
14: Card: Data that was saved as "Card"
Data that was saved using this
operation:
01 All Data
02:Synthesizer All
03:Sequencer All
04:1 Song
05:Song ESEQ
06:MIDl File
07:Card
above shows, load operation types 1 and 4-9
can only be used to load data saved as "All
Data." Load operations type 2 and 3 are used to
load data saved as "Synthesizer All" and
"Sequencer All", respectively. Load operation
type 14 is used to load data saved from a data
card.
JUMP #817
an be loaded using this
operation:
01:AII Data, 04:Syn Setup
05:Vc & Mit, 06:Pan
07:McrTuning,
08:Seq Setup
09:Song & Ptn, 1 1 : 1 Voice
12:1 Multi
2:Synth All
3:Seq All
13:1 Song
10:0ther Sequence
10:0ther Sequence
14:Card