A Scat Seta Aves; Assign Mode, Performance Name - Yamaha V50 Operating Manual

PERFORMANCE EDIT
eO ES
E Settings
i Up to 10 characters
ciate ey - , E Explanation
Use this function to give a name to a performance.
7 (Page 17 explains how to enter characters.) When
(1) Assign mode editing an existing performance, the original per-
E Function formance name will be displayed. When editing a
Set the key assign. performance from an initialized condition, the ini-
i tialized name will be displayed.
E Settings
normal, alternate, DVA
Notes on
E Explanation
This determines the instrument that will be played
when a key is pressed. Press [TR2] (NOTES).
normal If assign mode has been set to normal or al-
Normal assign is when each instrument plays as it ternate
receives data on its own receive channel (see page 25).
The maximum number of notes for each instrument
will be determined by the note setting (see page 24).
The upper line will show the receive channel and voice
of the instrument where the cursor is located.
alternate
Alternate assign is when instruments with the same
receive channel as instrument i will play alternately.
DVA E Function
Dynamic Voice Allocation is when each instrument Set the maximum number of notes for each instrument
plays in response to data on its own receive channel E Settings
(see page 25). The maximum number of notes for each 0—16 (total of all instruments must not be greater
instrument will be determined automatically as than 16) ç
needed. When using a sequencer to play the V50 it S
@ Explanation
is usually a good idea to set the assign mode to DVA. y . i
This determines the maximum number of notes that
Note: an instrument will be able to play simultaneously.
When using alternate assign, the keyboard transmit For example, if maximum notes is set at 4, the in-
channel (see page 99) must match the receive channel strument will be able to play chords with up to 4 notes.
of instrument 1. When you play a fifth note, the first- played note
Data such as control change, pitch bend, and will disappear, and the last played note will sound.
aftertouch will be received on the receive channel of
instrument |, and will apply to each instrument that
is alternate assigned.
When this mode is changed, settings for Max
Note and Reserve Notes will be set to match the
number of instruments being used.
Note:
When using a voice whose envelope generator is set
to a low RR (release rate) so that the sound lingers
for a while after the key is released, it is a good idea
to set a slightly higher maximum notes setting for that
voice. This will prevent the decay from being cut off
unnaturally.
24 = Performance Edit