Copy Pan Data; Pan Source - Yamaha SY99 Owner's Manual

COMMON DATA / ELEMENT DYNAMIC PAN
Summary: This function copies dynamic pan data
from another memory into an Internal pan data
memory.
Procedure:
When: editing dynamic pan data
Press: COPY to get the following display.
Specify: the source and destination pan.
To copy: the pan data press F8.
To quit: without copying press EXIT.
COMMON DATA / ELEMENT DYNAMIC PAN
Summary: This determines how the dynamic pan-
ning will be affected; either by Velocity, or Note
Number, or LFO.
Procedure:
From: Dynamic Pan Edit job directory
Select: 01:Pan Source
Specify: the pan source and depth
Pan Source (Velocity, Key Note Number, LFO):
Select the control source which will affect
dynamic panning. When velocity is selected, the
strength at which each note is played will affect
panning. When note number is selected, notes
above middle C will be panned increasingly right,
and notes below middle C will be panned in-
creasingly left. When LFO is selected, the LFO
of the element will continuously pan the sound.
Source Depth (0...127): This determines how
much the selected Pan Source will affect pan-
ning. When this is set to 0, the selected pan

6.0.1 Copy pan data

Remarks: Only Internal Pan Data memories can be

6.1 Pan source

Remarks: Dynamic panning is controlled by two
Source Pan: Select the dynamic pan data to copy.
Destination Pan: Select the dynamic pan data
(internal 1-32) into which to copy the Source
Pan data.
After selecting Source Pan and Destination Pan,
press F8 (Go) to copy the data. You will be
asked "Are you sure?". Press YES and the data
will be copied.
edited. If you want to edit one of the preset pan
tables, use this function to copy it into an Inter-
nal pan memory.
source will have no effect. When this is set to
127, the selected pan source will pan the ele-
ment from full left to full right.
factors working together; the Pan Source and the
Pan EG. Refer to the diagram in 6.2 Pan EG for
an example of this.
VOICE EDIT MODE
101