Voice Select - Yamaha SY99 Owner's Manual

MULTI EDIT MODE
02: Volume (Voice Volume): The volume of the
voice played by each channel of the multi can
be adjusted.
03: Tuning (Voice Tuning): The fine tuning of the
voice played by each channel of the multi can
be adjusted in steps of 1.1718875 cents.
04: Shift (Voice Note Shift): The pitch of the
voice played by each channel of the multi can
be adjusted in half steps.
05: St-Pan (Voice Static Pan): A fixed stereo
position can be specified for the voice played
by each channel of the multi, or a voice can
use its own pan settings.
06: OutSel (Voice Output Group Select): Each
voice played by the multi can be sent from
output group 1 and/or 2.
Summary: A multi consists of sixteen voices which
are controlled by MIDI channels 1-16. A differ-
ent voice can be selected for each of the sixteen
channels in the multi.
Procedure:
From: multi job directory
Select: job 01:Voice
Specify: the voice for each channel of the multi
This displays the number and name of the multi
you are editing.
This displays the number and name of the voice
where the cursor is located.
Move the cursor in this area and select a voice
for each of the sixteen channels in the multi. This
area displays only the first seven characters of
the selected voice name, but the voice number
and name are fully displayed in
of the multi can use any voice from internal, card,
or preset memories, or can be set to an "off"
voice. See Off Voice below for details.
188

1. Voice select

(JUMP #400)
(JUMP #401)
. Each channel
07: Effect (Effect Set): Specify how the effect
units are connected, how the sound from
each voice of the multi is sent to the effect
units, parameters for each effect unit, and
how the effect parameters are controlled in
realtime.
08: Name (Multi Name): The multi being edited
can be given a twenty-character name. In
multi play mode this name will be displayed
in large characters.
15: Initlz (Initialize Multi): The multi data being
edited can be initialized to a set of standard
values.
16: Recall (Recall Multi): The previously edited
multi data can be recalled for additional
editing.
A multi in card memory can use only card or
preset voices. A multi in internal memory can
use only internal or preset voices.
If a selected voice contains an AWM ele-
ment which uses data from a waveform card, the
card must be inserted into the WAVEFORM
slot for the voice to sound properly. If a different
card is inserted, a diamond-shaped mark will
appear in place of the voice number 1-16, and
the voice will sound strange. (Each AWM
waveform card has a unique ID number which is
stored as part of the data for an AWM element.)
To edit the voice selected by the cursor, press F8
(Edit). You will enter voice edit mode. Details
are the same as explained in Voice edit mode,
but when you press EXIT to exit voice edit mode
you will return to this Multi edit 1. Voice select
job.
Since the effect unit settings in multi mode
are determined by Multi edit 7.Effect set (JUMP
#412) and are shared by all the voices of the
multi, you will not be able to modify the Effect
Mode, the Effect Parameters, or the Effect Con-
trol settings. You can adjust the Effect Send
settings of the voice, but for these settings to be
effective in a multi, the Multi edit 7.2 Effect send
must be set to "VC" for that voice.
JUMP #401