Pattern Realtime Record - Yamaha SY99 Owner's Manual

PATTERN MODE
Pattern recording procedure:
1. Select the pattern to record.
2. If the selected pattern has not yet been
recorded, specify the time signature and length.
3. Make setting for tempo, quantize, receive chan-
nel, click, click beat, and sync.
4. Specify the recording mode; realtime (F1) or step
(F2).
5. Press RUN and pattern recording will begin. The
recording display will depend on the recording
PATTERN RECORD
Summary: In realtime recording the notes you play
will be recorded in the exact timing at which you
play them. Newly recorded notes will be added
to the previous data in the pattern.
Procedure:
From: pattern record display
Press: F1 (Real) to select realtime recording.
To begin: recording press RUN. The RUN LED
will blink at tempo.
To stop: recording and return to the song play
display press STOP.
Measure (01...32): As you record this will ad-
vance to Show the currently recorded measure
number of the pattern.
(30...250); While recording you can move the
cursor here to modify the tempo.
Used (0...100%): As you record this will in-
crease to show the amount of sequencer memory
that has been used.
Click (off, rec, rec/play, always): While recording
you can move the cursor here and specify when
the click (metronome) will sound.
off: The metronome will not sound.
rec: The metronome will sound only during
recording.
rec/play: The metronome will sound during
recording or playback.
always: The metronome will sound constantly.
238

Pattern realtime record

mode selected in step 2. For details see the fol-
lowing sections; Pattern realtime record or pat-
tern step record.
6. When you are finished recording press STOP and
you will return to the pattern play display.
Pattern edit: Any time while in pattern record mode
you can press EDIT to edit the pattern. For de-
tails refer to Pattern edit mode.
Click.Beat (1/4,1/6, 1/8, 1/12, 1/16, 1/24): While
recording you can move the cursor here and
specify the beat on which the click will sound.
Remarks: While recording you can modify the set-
tings for tempo, click, and click beat. To modify
the other parameters you must return to the pat-
tern record display.
Unlike song realtime recording, pattern real-
time recording gives you no choice of overdub or
replace recording modes. Pattern recording is
always in overdub mode, meaning that newly
recorded notes will be added to the previous
data in the pattern.
In realtime pattern recording the pattern will
continue to repeat from beginning to end until
you press STOP. This allows you to build up
complex rhythmic parts one note at a time.
To delete: During realtime recording, you can
delete any given note from the pattern by
pressing SHIFT while holding down the key of the
unwanted note.
Allow the pattern to run through the section
you wish to erase.
Important: Pattern data may be recorded when the
SY99 is in Voice mode. However, this data will
not be played when the SY99 is in Voice mode
unless the voice receive channel is set to the
pattern track's transmit channel (usually chan-
nel 16) or "omn" (which means the voice will
play data received on all channels). Refer to the
explanation of the voice receive channel setting
on page 258.