Copy Micro Tuning - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
COMMON DATA / MICRO TUNING SET
Summary; This function copies micro tuning data
from another memory into an Internal micro tun-
ing memory.
Procedure:
When: editing micro tuning data
Press: COPY to get the following display.
Select: the micro tuning copy source and destina-
tion
To copy: the data press F8
To quit: without copying press EXIT
COMMON DATA / MICRO TUNING SET
Summary: Edit the tuning for each note of the
selected micro tuning data.
Procedure:
From: Micro Tuning Edit job
directory
Select: 01:Micro Tuning Data
Specify: the tuning for each note
The number and name of the micro tuning data
being edited are displayed.
The previous note and its absolute tuning value.
The note whose tuning you are editing.
Coarse Tuning (C#-1...G8): With the cursor
located at Coarse, adjust the tuning of the cur-
rently edited note in half steps.
Fine Tuning (-43 or -42...+42): With the cursor
located at Fine, adjust the tuning of the currently
126

11.0.1 Copy micro tuning

(JUMP #223, #224)
11.1 Micro tuning data
(JUMP #222)
(JUMP #223)
Source Tuning (I-1, I-2, C-l, C-2, P-1...P-64):
Select the micro tuning data to copy. C-l and C-2
(card) can be selected only if a VOICE card is
Destination Tuning (I-1, I-2): Select the micro
tuning (internal 1 or 2) into which to copy the
Source Tuning data.
After selecting Source Tuning and Destination
Tuning, press F8 (Go) to copy the data. You will
be asked "Are you sure?". Press YES and the
data will be copied.
Remarks: Only Internal micro tuning data can be
edited. If you want to edit one of the preset or
card micro tunings, use this function to copy it
into an Internal micro tuning memory.
edited note in fine steps of 1.171875 cents. The
absolute tuning value displayed in parentheses
indicates the number of these steps starting
from 0 steps at C#-2. The lowest setting of this
parameter will be either -43 or -42 depending on
the Coarse Tuning value.
The next note name and its absolute tuning
value.
Pressing F1 (K-Dn) or F2 (K-Up) will move to
the previous or next note. You can also play a
note on the keyboard to select a note at any
time.
Remarks: First use F1 (K-Dn) and F2 (K-Up) to
select the note you want to edit. You can also
use the SY99 keyboard to select the note. The
currently edited note will appear in the center of
the display, with the previous note shown at left
and the next note shown at right.
Next set the Coarse and Tune tuning for the
selected note. If you adjust Fine Tuning beyond
the range of ±42, the Coarse Tuning will be
moved up or down as appropriate.
JUMP #223