Yamaha SY99 Owner's Manual page 297

UTILITY MODE
Control setup data: Each of the four zones of a con-
trol setup contains the following data items:
ON/OFF: Zones that are turned off will not transmit
data.
Transmit channel (1... 16): The data for the zone will
be transmitted on this MIDI channel.
Velocity curve (1...4): This determines how the
note-on velocity of notes played will relate to the
note-on velocity of the notes transmitted by this
zone. (Refer to System utility 2 .Velocity set,
page 253.)
Aftertouch curve (1...4): This determines how pres-
sure on the keyboard will be transmitted as
channel aftertouch messages by this zone.
Bank Select (off, 1-16384): A bank select message
of this number will be transmitted by this zone
when the control setup is selected.
Program Change (off, 1-128): A program change
message of this number will be transmitted by
this zone when the control setup is selected.
Volume (off, 0...127): A volume message (control
change 7) will be transmitted by this zone when
the control setup is selected.
MDR data set (off, 1...99): The specified set of bulk
data will be transmitted when the control setup
is selected. (Refer to MIDI data recorder utility,
page 279.) If there is a large amount of bulk data
in the selected MDR data set, there may be a
noticeable delay while this data is transmitted
before the keyboard will respond to your playing.
Transpose (-64...+64): The notes transmitted by
the zone will be transposed by this amount.
Note Limit (C-2...G8): The zone will transmit only
notes whose note number is inside this range
within.
286
Velocity Limit (1...127): The zone will transmit only
notes that have a note-on velocity within this
range.
Control setup factory presets: The following eight
control setups were programmed to your SY99
when it left the factory:
Setup Name
Normal 1Vc Normal MIDI output. These settings are
loaded by the initialize operation.
Normal 4Vc Simultaneous four-channel MIDI output.
Key split Two-channel output for each of the upper
and lower halves of the keyboard;
keyboard split at center.
Velo split Two-channel output split at velocity median
value.
Majr7 chrd
Transposes output to major seventh chord
structure.
Minr7 chrd Transposes output to minor seventh chord
structure.
7th chrd Transposes output to seventh chord
structure.
7sus4 chrd Transposes output to seventh sus4 chord
structure.
We recommend saving these settings to a disk or
data card, as they will be lost once they are edited.
Control setup chart: You can copy the chart on the
next page to keep records of your own settings.
Summary: Edit the settings of the selected con-
troller to specify how it will transmit data on
each of its four zones.
Description