Table 3.5 Effect On The Menu Of The Mmb Due To Extended Partitioning Mode Change - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 3 Component Configuration and Replacement (Add, Remove)
3.2 High availability configuration
For details of [Mode] window, see '1.3.9.4 [Mode] window' in "PRIMEQUEST 2000 series Tool Reference"
(CA92344-0539).
Setting of Extended Partitioning mode
Extended Partitioning is enabled by the following procedure.
1. Set the [Extended Partitioning Mode] to 'Enable' from the [Partition]-[Mode] menu.
2. Click the [Apply] button.
The confirmation dialog box appears.
3. Click the [OK] button.
Note
When [Extended Partitioning Mode] is 'Enable', you cannot set [Dynamic Reconfiguration] to 'Enable'.
Extended Partitioning is disabled by the following procedure.
A partition where Extended Partitioning is disabled operates as a physical partition from next startup.
1. Set the [Extended Partitioning Mode] to 'Disable' from the [Partition]-[Mode] menu.
2. Click the [Apply] button.
The confirmation dialog box appears.
3. Click the [OK] button.
Note
Even if [Extended Partitioning Mode] is set to 'Disable', the configuration information such as Extended
Partition number and allocation of resources is saved.
The following is the window of the MMB affected by the Extended Partitioning mode.

TABLE 3.5 Effect on the menu of the MMB due to Extended Partitioning mode change

Menu
Partition Power Control
Console
Redirection
Partition #n →
Mode
Power control of Extended Partitioning
The power on/off status of the Physical partition and Extended Partition are listed in the [Partition]-[Power
Control] window of the MMB Web-UI. The user specifies the Physical partition or the Extended Partition from
the list and turns on/off the partition power.
- When turning on the power of the first Extended Partition on the Physical partition, the Extended Partition
would be powered on after the Physical Partition powered is turned on
- When turning off the power of the last Extended Partition on the Physical partition, the Extended Partition
is first powered off, followed by the power off for the Physical partition.
The following power operations are possible in the Extended Partitioning mode.
- All Partition Power On
- All Partition Power Off
- Partition Power On
Effect due to Extended Partitioning
mode setting
On: Power operation of Physical
partition is not possible
Off: Power operation of Extended
Partition is not possible
On: Parent Physical partition cannot
be set (gray out)
Off: Gray out cancel
On: Setting change other than
Extended Partitioning mode will not
be possible for the Physical partition
(grayed out)
Off: Gray out cancel
44
Reference
'FIGURE 3.6 Example of
[Power Control] window
(Extended Partitioning is
enabled.)'
'FIGURE 3.11 Example of [IPv4
Console Redirection Setup]
window' 'FIGURE 3.12
Example of [IPv6 Console
Redirection Setup] window'
'FIGURE 3.13 Example of
[Mode] window of physical
partition'
CA92344-0537-08