Figure 1.3 Management Lan Configuration; Table 1.4 Restrictions On The Management Lan - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 1 Network Environment Setup and Tool Installation
1.3 Management LAN
No.
(1)
(2)
(3)
If either USER port fails, the interface redundancy function switches to the other port in the MMB to ensure
continuous service. If a failure occurs in the active MMB itself, the Virtual LAN channels become unusable.
Then, the standby MMB inherits the virtual IP address from the active MMB to ensure continuous service.
The following interfaces are available with a configured management LAN:
Interfaces available to the system administrator:
- Web-UI interface using HTTP/HTTPS
- CLI interface via telnet/SSH
- Partition and console operations through the video redirection function
Interface available to system management software:
- RMCP and RMCP + interface
Remarks
The restrictions on management LAN interfaces other than Virtual LAN channels are described below.
Channel name
Virtual LAN channel
Physical LAN channel (Active MMB)
Physical LAN channel (Standby MMB) (*1)
*1 Only PRIMEQUEST 2400E3/2800E3/2400E2/2800E2/2400E/2800E can have two MMBs. PRIMEQUEST
2800B3/2800B2/2800B can have only one MMB.
*2 The connection cannot send or receive data of over 4 Kbytes.
*3 The connection sends data to the active MMB, so adequate performance cannot be obtained.
*4 Only the following commands can be executed:
- Set command
set active_mmb 0
- Show commands
show active_mmb

FIGURE 1.3 Management LAN configuration

Physical LAN IP example (MMB #0): 10.20.30.101
Physical LAN IP example (MMB #1): 10.20.30.102
Virtual LAN IP example: 10.20.30.100

TABLE 1.4 Restrictions on the management LAN

RMCP connection
Possible
Possible
Possible with
restrictions (*2)(*3)
Description
Web-UI connection
(UDP) (http/https)
Possible
Not possible
Not possible
6
CLI connection
(telnet/ssh)
Possible
Possible
Possible with
restrictions (*4) (*5)
CA92344-0537-08