Fujitsu PRIMEQUEST 2000 Series Administration Manual page 217

CHAPTER 5 Hot Maintenance in Red Hat Enterprise Linux 7
5.8 Hot Addition of PCI Express cards
7. Maintenance mode is set (with information area of MMB Web-UI gray out) and then replacement
instruction for the particular PCIC appears. Add a new PCI Express card with this window displayed.
See the figure in
Express card to be replaced.
Note
Do NOT click [Next] until adding the PCIC.
8. After adding the particular PCIC, mount cables other than LAN cables.
Note
In GLS configuration with NIC switching way, mount also LAN cables.
9. Powering on the particular PCIC slot, click [Next].
For how to power on the PCIC slot, see "Powering on and off PCI Express slots" in
card addition procedure in
It is the administrator of your system who power on the PCI Express slot.
Note
Ask the administrator of your system to power on the PCI Express slot.
'B.1 Physical Mounting Locations of
detail".
Components' to confirm the location of the PCI
191
"5.8.2 PCI Express
CA92344-0537-08