Fujitsu PRIMEQUEST 2000 Series Administration Manual page 349

CHAPTER 9 PCI Express card Hot Maintenance in Windows
9.4 FC Card Hot Plugging
3. Confirm physical location, segment number and bus number of target NIC.
Confirm the physical location, segment number and bus number with step 1 at
procedure' in
Note
In case of multi-function card, there are some cards that have same segment number, same bus number,
and different function numbers.
In this case, please perform Step.4 to Step.8 of follows respectively.
4. Confirm target device by using administration manager of the FC card, and confirm WWN, port number,
and firmware version.
Case: Emulex FC card
a Open OneCommand Manager, confirm target device with step 3.
Select Port WWN as the same type of target FC card in left pane, and select [Port Information] tab in
right pane.
See "PCI Bus Number" in [Port Attributes], and look for the device which has same bus number you
confirmed in step 3.
'9.2 Common Hot Plugging Procedure for PCI Express
323
'9.2.1 Replacement
cards'.
CA92344-0537-08