Figure 6.3 Single Nic Interface And Bonding Configuration Interface; Network Card Addition Procedure - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 6 PCI Card Hot Maintenance in SUSE Linux Enterprise Server 11
6.2 Hot Addition of PCI Express cards
7. Power on the PCI Express slot.
See 'Powering on and off PCI Express slots' in
8. Check whether there is an error in added FC card by MMB Maintenance Wizard.
This step is performed by the field engineer in charge of your system.
For details on the operation of replacement, see step 8 to 11 of 'Operation for Hot replacement of PCI
Express card by Maintenance Wizard' in
9. Check the version of the firmware
It is required that the firmware version of new FC card is same as the FC card which had been replaced.
If the firmware version of new FC card is same as the FC card which had been replaced (current firmware
version), it is not necessary to update the firmware version of new FC card to current firmware version.
If the firmware version of new FC card is not same as the FC card which had been replaced (current
firmware version), update the firmware version of new FC card to current firmware version.
For how to update the firmware version, see Firmware update manual for fibre channel card.
Note
If you cannot confirm the firmware version of the FC card before replacing due to the fault of the FC card,
check the firmware version of the FC card which is same type as the faulty one to update firmware
version.
10. Confirm the incorporation results
The method of confirming is the same as that is performed in the replacement of FC card. See
'Confirming the FC card incorporation
procedure'.

6.2.4 Network card addition procedure

NIC (network card) addition using hot plugging needs specific processing before and after PCI slot power-on
or power-off. Its procedure also includes the common PCI Express card addition procedure.
The procedure describes operations where a single NIC is configured as one interface. It also describes
cases where multiple NICs are bonded together to configure one interface (bonding configuration). For
bonding multiple NIC by using PRIMECLUSTER Global Link Services (GLS), see 'PRIMECLUSTER Global
Link Service Configuration and Administration Guide Redundant Line Control Function' (J2UZ-7781).
NIC addition procedure
This section describes the procedure for hot plugging only a network card.
Note
When adding multiple NICs, be sure to add them one by one. If you do this with multiple cards at the same
time, the correct settings may not be made.
1. Confirming the installation of the PCI Hot Plug driver
See 'Confirming the installation of the PCI Hot Plug driver' in
procedure in
2. Confirm the existing interface names.
To confirm the interface names, execute the following command.
Example: eth0 is the only interface on the NIC.
# /sbin/ifconfig -a
eth0
BROADCAST MULTICAST MTU:1500 Metric:1

FIGURE 6.3 Single NIC interface and bonding configuration interface

detail".
Link encap:Ethernet HWaddr 00:0E:0C:70:C3:38
"6.1.2 PCI Express card replacement procedure in
"6.2.2 PCI Express card addition procedure in
results' in '6.1.3 FC card (Fibre Channel card) replacement
"6.1.2 PCI Express card replacement
228
detail".
detail".
CA92344-0537-08