Fujitsu PRIMEQUEST 2000 Series Administration Manual page 363

CHAPTER 9 PCI Express card Hot Maintenance in Windows
9.5 Hot Replacement Procedure for iSCSI
6. Replace NIC by using MMB Maintenance Wizard.
Replace NIC with step 4 at
Express cards. This step is performed by the field engineer in charge of your system.
Note
In case of using SVagent, "Source:Svagent, ID: 25004 Error massage" is logged in SEL when replacing, it
is no problem.
7. Set an IP address for the replacement device.
Set the IP address and subnet mask recorded in step 2.
Remarks
If the following message appears when you set the IP address, select [Yes].
8. Click the [Refresh] button on the [Targets] tab in the [iSCSI Initiator Properties] window. Confirm that the
target status becomes [Connected].
9.2.1 Replacement procedure
337
in 9.2 Common Hot Plugging Procedure for PCI
CA92344-0537-08