Fujitsu PRIMEQUEST 2000 Series Administration Manual page 272

CHAPTER 7 PCI Card Hot Maintenance in SUSE Linux Enterprise Server 12
7.4 Hot replacement of IOU
0000:82:00.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:83:09.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:84:00.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:02.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:08.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:09.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:10.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:85:11.0 PCI bridge: PLX Technology, Inc. Device 8748
(rev ca)
0000:89:00.0 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:89:00.1 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8c:00.0 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8c:00.1 Ethernet controller: Intel Corporation I350
Gigabit
Network Connection (rev 01)
0000:8f:00.0 Fibre Channel: Emulex Corporation Saturn-X:
LightPulse
Fibre Channel Host Adapter (rev 03)
0000:8f:00.1 Fibre Channel: Emulex Corporation Saturn-X:
LightPulse
Fibre Channel Host Adapter (rev 03)
NIC on the IOU (including onboard NIC)
For replacing IOU itself (replacement of onboard NIC) or expanding, replacing or removing NIC on the IOU,
not only common procedure of IOU replacement but also special procedure before and after powering on or
powering off IOU is needed. Here describes case of replacement of IOU itself. (otherwise add note) The
procedure describes operations where a single NIC is configured as one interface. It also describes cases
where multiple NICs are bonded together to configure one interface (bonding configuration).
Although name form of NIC differs depending on mounting location of the NIC in SLES12, conventional 'ethX'
is used in below description. 'ethX' should be replaced to actual name of the NIC as necessary.
Notes
- To perform hot replacement in a system where a bonding device is installed, design the system so that it
specifies ONBOOT=YES in all interface configuration files (the /etc/sysconfig/network/ifcfg-eth*files and
the /etc/sysconfig/network/ifcfg-bond*files), regardless of whether the NIC to be replaced is a
configuration interface of the bonding device.
An IP address need not to be assigned to unused interfaces. This procedure is to prevent the device
name of the replacement target NIC from being changed after hot replacement. If ONBOOT=NO also
exists, the procedure described here may not work properly.
246
CA92344-0537-08