Table 11.8 Power Restoration Policy - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 11 Chapter System Startup/Shutdown and Power Control
11.5 Power Restoration
Items
Software Watchdog
Software Watchdog
Timeout time (seconds)
Action when watchdog
expires
3. Disable 'Boot Watchdog' to cancel the Boot Watchdog function.
4. Click [Apply] button.
Set the operating system Boot monitoring cancellation.
For details on the operation of [ASR Control] window, see '1.3.9 [Partition#x] menu' in "PRIMEQUEST 2000
series Tool Reference" (CA92344-0539).
11.5 Power Restoration
In the PRIMEQUEST 2000 series, the system operations for power restoration can be set in the chassis unit.
This can be set by MMB Web-UI.
11.5.1 Settings for Power Restoration
When using a UPS, the following items can be set when a power failure is detected. The default is "Restore".
Item
Always Off
Always On
Restore
Schedule Sync
*1: For details on the scheduled operations, see
If the startup of an external SAN unit connected to the UPS and such unit is slow during power restoration,
then the SAN device does not become usable if the partition is powered on by the server. Therefore, SAN
boot may fail. In that case, "Partition Power On Delay" (units of seconds: 0 to 9999 seconds, default = 0
seconds) can be set in addition to the above mentioned settings.
For details on the method of settings for power failure/restoration, see '1.2.7 [System Setup] window' in
"PRIMEQUEST 2000 series Tool Reference" (CA92344-0539).
Description
- Continue
- Reset
- Power Cycle
Enable/disable of the Software Watchdog function of ServerView is set.
After OS starts, the operation of OS is observed by ServerView when setting it to
Enable.
Default is Disable.
Time until Software Watchdog does timeout is set.
The range of 1-6000 can be set. (for Linux, Windows)
The range of 240-6000 can be set (for VMware)
Default is 300 seconds (=5 minutes).
Action when Software Watchdog does timeout is set.
In Action, there is the following.
- Continue
- Reset
- Power Cycle
- NMI
Note
For VMware, you can select only 'Continue'.

TABLE 11.8 Power Restoration Policy

Continues the power off status after the power is restored.
Power on the partition after restoring the power irrespective of
the status of the power failure.
Returns to the state at the time when the power failure occurred.
Powers on the partitions that were On when the power failure
occurred, and retains the power off status for partitions that were
powered off when the power failure occurred.
Automatically powers on the partition, according to the
scheduled operation settings when a power failure had occurred
during working hours. (*1)
System operation
'11.3 Scheduled operations'.
352
CA92344-0537-08