Fc Card Addition Procedure - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 9 PCI Express card Hot Maintenance in Windows
9.5 Hot Replacement Procedure for iSCSI
14. Restart services for only Qlogic FC cards.
Using 'Services' window in 'Computer Management', restart 'QLogic Management Suite Java Agent'.

9.4.2 FC card addition procedure

Referring to 9.2 Common Hot Plugging Procedure for PCI Express
9.5 Hot Replacement Procedure for iSCSI
The prerequisites for iSCSI (NIC) hot replacement are as follows.
- The maintenance person has the Administrator privileges required for operations.
- The ETERNUS multipath driver (MPD) has been applied.
- To replace more than one card, one card at a time will be replaced.
9.5.1 Confirming the incorporation of a card with MPD
This section describes the procedure for confirming that a card has been incorporated with MPD.
1. Confirm physical location, segment number and bus number of target NIC.
Confirm the physical location, segment number and bus number with step 1 at
procedure
Note
In case of multi-function card, there are some cards that have same segment number, same bus number,
and different function numbers.
In this case, please perform Step.2 to Step.7 of follows respectively.
2. Confirm target NIC in Device Manager.
Confirm NIC with step 2-a at
PCI Express
3. Record IP address of target replaced NIC.
Open Command Prompt, command "ipconfig/all", and record information that is necessary to reconfigure
IP address, subnet mask and so on of NIC after replacement.
4. Open iSCSI initiator.
5. Click the [Targets] tab in the [iSCSI Initiator Properties] window. One of the targets displayed in
[Discovered targets] is connected to the NIC to be replaced. If you know which target, select the target,
click the [Devices] button, and proceed to step 10.
If you do not know, select any target, click the [Properties] button, and proceed to step 7.
in 9.2 Common Hot Plugging Procedure for PCI Express
9.2.1 Replacement procedure
cards.
cards, add an FC card.
cards.
in 9.2 Common Hot Plugging Procedure for
332
9.2.1 Replacement
CA92344-0537-08