CHAPTER 9 PCI Express card Hot Maintenance in Windows
9.2 Common Hot Plugging Procedure for PCI Express cards
6. Mount all cables connected to the particular PCI card.
This step is performed by the field engineer in charge of your system.
9.2.2 Addition procedure
1. Confirm the physical location, segment number, and bus number.
Confirm the mounting location of the PCI card.
See the figure in
and slot) of the PCI card.
2. Add PCI card by using MMB Maintenance Wizard.
This section describes the procedures of hot addition of PCI cards (PCIC) using Maintenance Wizard.
This step is performed by the field engineer in charge of your system.
1. Open [Maintenance Wizard] menu in MMB Web-UI, and open [Maintenance Wizard].
2. Check [Replace Unit] button, and click [Next] button.
B.1 Physical Mounting Locations of Components
to check the mounting location (board
311
CA92344-0537-08