Hardware Installation; Connecting The Power; Grounding The Iologik E1200; Connecting To The Network - Moxa Technologies ioLogik E1210 User Manual

ioLogik E1200 User's Manual

Hardware Installation

Connecting the Power

Connect the 12 to 36 VDC power line to the ioLogik E1200's terminal block on the top panel. If
power is properly supplied, the Power LED will glow a solid amber color.
ATTENTION
Disconnect the power before installing or wiring
Disconnect the power cord before installing or wiring your ioLogik E1200.
Do not exceed the maximum current for the wiring
Determine the maximum possible current for each power wire and common wire. Observe all
electrical codes dictating the maximum current allowable for each wire size. If the current
exceeds the maximum rating, the wiring could overheat, causing serious damage to your
equipment. For safety reasons, the wires attached to the power should be at least 2 mm in
diameter.

Grounding the ioLogik E1200

The ioLogik E1200 is equipped with a grounding point on the terminal block located on the top
panel.
Connect the ground pin (

Connecting to the Network

1. The ioLogik E1200 has two built-in Ethernet switch ports for connecting a standard direct or
cross-over Ethernet cable from either RJ45 port to the host PC. For initial setup of the ioLogik
E1200, it is recommended that the ioLogik E1200 be configured using a direct connection to a
host computer rather than remotely over the network.
2. Configure the host PC's IP address to 192.168.127.
When using Windows, you will need to do the configuration from the Control Panel.
ioLogik E1200 Default IP Address
192.168.127.254
3. Use the web console or ioSearch configuration utility to connect to the ioLogik E1200. Once
the ioLogik E1200 has been detected, modify the settings as needed for your network
environment, and then restart the server.
) if earth ground is available.
Default Netmask
255.255.255.0
2-2
(where ranges from 001 to 253).
xxx xxx
Default Gateway
None
Initial Setup