Hardware Installation Procedure; Wall Mount - Moxa Technologies NPort IA5150 Series Quick Installation Manual

Hardware Installation Procedure

STEP 1: Connect the NPort IA to a network. Use a standard straight-
through Ethernet cable to connect to a hub or switch. When setting up
or testing the NPort IA, you might find it convenient to connect directly
to your computer's Ethernet port. In this case, use a crossover Ethernet
cable.
STEP 2: Connect the NPort IA's serial port to a serial device.
STEP 3: The NPort IA is designed to be attached to a DIN rail or
mounted on a wall. The two sliders on the NPort IA's rear panel serve a
dual purpose. For wall mounting, both sliders should be extended. For
DIN-rail mounting, start with one slider pushed in, and the other slider
extended. After attaching the NPort IA on the DIN rail, push the
extended slider in to lock the device server to the rail. The two
placement options are illustrated in the accompanying figures.
STEP 4: Connect the 12 to 48 VDC power line with the NPort IA's
terminal block or connect the DIN-rail power supply with the NPort IA's
terminal block.
Power Input and Relay Output Pinouts
V2+
Shielded DC Power
Ground Input 1
Wallmount
Wall or Cabinet Mounting
Mounting the NPort IA5000 Series on to a wall
requires two screws. The heads of the screws
should be 5 to 7 mm in diameter, the shafts should
be 3 to 4 mm in diameter, and the length of the
screws should be more than 10.5 mm.
V2-
DC
Relay
Power
Output
Input 1
- 4 -
Relay
Power
Output
Input 2
DIN Rail
V1+ V1-
DC DC
Power
Input 2