Table of Contents
Advertisement
NPort IA5000A Series LED Indicators (front panel)
Name
Color
PWR1,
Red
PWR2
Red
Ready
Green
Off
Orange 10 Mbps Ethernet connecting.
E1, E2
Green
Off
Orange Serial port is receiving data.
P1, P2,
Green
P3, P4
Off
Hardware Installation Procedure
STEP 1: After removing the NPort IA5000A Series from the box, the
first thing you should do is connect the power adapter. Connect the 12-
48 VDC power line with the NPort IA5000A Series' terminal block, or
connect the DIN-Rail power supply with the NPort IA5000A Series'
terminal block.
STEP 2: Connect the NPort IA5000A Series to a network. Use a
standard straight-through Ethernet cable to connect to a hub or switch.
When setting up or testing the NPort IA5000A Series, you might find it
convenient to connect directly to your computer's Ethernet port. In this
case, use a crossover Ethernet cable.
STEP 3: Connect the NPort IA5000A Series' serial port to a serial
device.
STEP 4: The NPort IA5000A Series is designed to be attached to a DIN-
rail or mounted on a wall. For DIN-rail mounting, push down the spring
and properly attach it to the DIN-rail until it "snaps" into place. For wall
mounting, install the wall-mount kit (optional) first, and then screw the
device onto the wall.
Function
Power is being supplied to power input PWR1,
PWR2.
Steady on: Power is on and the NPort IA5000A
Series is booting up.
Blinking: Indicates an IP conflict, the DHCP or
BOOTP server did not respond properly, or a relay
output occurred.
Steady on: Power is on and the NPort IA5000A
Series is functioning normally.
Blinking: The device server has been located by the
Administrator's "Locate" function.
Power is off, or a power error condition exists.
100 Mbps Ethernet connecting.
Ethernet cable is disconnected, or has a short.
Serial port is transmitting data.
No data is being transmitted or received through
the serial port.
- 4 -
Advertisement
Table of Contents
