Hardware Installation - Moxa Technologies NPort 5600-8-DT Quick Installation Manual

LED Indicators
The LED indicators on the top panel are used to display status as
follows:
Name
PWR
Ready
Fault
Link
InUse
(P1 to P8)
Tx/Rx
(P1 to P8)

Hardware Installation

STEP 1: After removing the NPort 5600-8-DT from the box, place it on
a desktop or other horizontal surface. Connect the 12-48 VDC power
adaptor to the NPort 5600-8-DT's power input when using an AC power
source, or connect the NPort 5600-8-DT's terminal block directly to a
DC power source.
STEP 2: Use an Ethernet cable to connect the NPort 5600-8-DT to a
network hub or switch. You can also connect directly to your computer's
Ethernet port, which is convenient for initial configuration or testing.
STEP 3: Connect the NPort 5600-8-DT's serial port to a serial device.
Wall or Cabinet Mounting
The NPort 5600-8-DT comes with two metal attachment plates to allow
installation on a wall or the inside of a cabinet. First, attach the
brackets to the back of the NPort with screws. Next, mount the unit on
a wall or cabinet with screws. Screws should be less than 6.0 mm in
head diameter, and less than 3.5 mm in shaft diameter.
Color Function
Red Power is on.
Off Power is off.
Steady:
Green
Blinking: NPort is responding to NPort
Off Power is off or fault condition exists.
IP conflict or DHCP or BOOTP server did not
Red
respond properly.
Off No fault condition detected.
Steady:
Green
Blinking: Network is connected, data is
Ethernet cable is disconnected or has a
Off
short.
Serial port has been opened by server side
Green
software.
Serial port is not currently opened by
Off
server side software.
Green (Tx) Serial device is transmitting data.
Orange (Rx) Serial device is receiving data.
No data is flowing to or from the serial
Off
port.
NPort is operational
Administrator "Locate" function
Network is connected, no data is
being transmitted.
being transmitted.
- 4 -