I/O Settings; Di Channels - Moxa Technologies ioLogik E1210 User Manual

ioLogik E1200 User's Manual

I/O Settings

DI Channels

The status of each DI (digital input) channel appears on the DI Channels page.
You can also configure each channel's digital input mode and parameters by clicking on the channel.
DI channels can operate in DI mode or Event Counter mode.
For Event Counter mode, configure the low width and high width in multiples of 1 ms. The counter
should be set to either start, or stop. If it is in stop mode, the counter can be activated by the Modbus
command. Make sure that the Counter Filter is not set to 0; otherwise, the counter will never be
activated.
The alias name and the logic definition can also be configured on this page.
3-6
Using the Web Console