Jumper Settings; I/O Wiring Diagrams - Moxa Technologies ioLogik E1210 User Manual

ioLogik E1200 User's Manual

Jumper Settings

The ioLogik E1212, E1240, and E1242 require configuring the jumpers inside the enclosure.
Remove the screw on the back panel and open the cover to configure the jumpers.
DIO mode configuration is as follows (default is DO Mode)
Analog mode configuration is as follows (default is Voltage Mode)
ATTENTION
Remove the screw on the back panel and open the cover to configure the jumpers.

I/O Wiring Diagrams

2-3
Initial Setup